restore
BRINGS OLD WOOD BACK TO NEW!
Simply Put - Awesome!
Cedar Shakes & Unpainted Wood Surfaces such as Decks – Stripping Antique Furniture Cleaning Tile Grout - Laundry Presoak & Bleach Replacement - Carpet Cleaning - Ceiling Tiles...
You just won’t find anything better than RESTORE!
For Cedar Shakes, unpainted Wood Decks and Asphalt Shingles simply spray RESTORE
on, wait 20 to 30 minutes, and rinse off. You will not believe your eyes! No
more harsh bleach or surface and vegetation aggressive chemicals. Totally
removes black mold and mildew build-up on shakes, regardless of how long it has
been there.
For restoring Antique furniture or furniture that has been stained pre-wet the
surface with a light mist of water. Sprinkle a small amount of RESTORE in dry
form on pre-wet surface. With a plastic scrub pad (the type that you would
normally use in the kitchen) gently work RESTORE into the wood and allow it to
stand 10-20 minutes. Rinse with a light mist of water. Do not soak the wood
with water - a light mist is all that is required to activate RESTORE. This
product will provide unbelievable results. You will be able to produce twice
the results in 1/3 the time and with little to no mess. You'll never use harsh
chlorine cleaners or solvent based strippers again.
RESTORE works by means of oxygenation and should not be mixed with water until
the operator is ready to perform the job. Once RESTORE is in solution, the
operator will have approximately 1-2 hours before the product has exhausted
itself. Mix up enough so that you will be able to get the product on the
surface within this time. Mix approximately 1/2 to 1 pound of RESTORE into 1
gallon of water and stir several turns. Complete solubility is not necessary
since RESTORE will go into solution on it’s own through the oxygenation process. When product has removed pollutant, rinse
with low pressure, 500 - 1000 PSI is all that is required. When using this
product on pressure treated wood we recommend the 1/2 lb to 1 gallon of water
ratio and rinsing with no more than 500 PSI. Higher dilutions and pressures
will cause the surface to ‘fuzz’ up. When this happens it is generally a temporary situation that will correct
itself in a couple of days.
Related Products: For application use p/n 1059 Delavan pump and lance assembly. Use 15 gallon tank p/n 1067. Another option is p/n 1883, 2 gallon pump up sprayer. Always rinse equipment with clean water at the end of each job. To set up other application systems check the EnviroSpec catalog for a large
assortment of direct sprayers, pumps, chemical line and fittings
***Do not use a pump-up sprayer to apply this product.***
Restore produces oxygen when mixed with water causing a build up of pressure and
the container may become over pressurized.
