strip-t-ease
pH: 12.4-12.6
Caustic: NO
Degreaser: YES
Phosphates: NO
Rinsing: EXCELLENT
Packaging: One 50-pound carton of powder and a liquid additive will yield 55 gallons of
liquid detergent concentrate. One power pack will yield 5 gallons of
concentrate.
Strip-T-Ease is a professional strength alkaline agent that is highly
recommended for stripping decks.
Mixing Instructions: Read and understand these instructions before starting to
mix this product. Use warm water, never hot (not to exceed 120 degrees F). Warm
water helps powders go into solution more easily. Hot water, on the other hand,
will blow apart many of the surfactants utilized in the formulary process. It
is possible to use cold water but additional manual agitation may be required.
Use a clean poly drum & fill it approximately 50% full with warm water. Place the nozzle of a
high-pressure washer close to the bottom of the drum and continue filling while
adding the powder slowly. When the drum is 90% full all the powder should have
been added. The liquid additive should be added at this point also. Continue filling until
the drum is full. The result is 55 gallons of liquid that is now ready for use.
Washing technique: Coat the surface to be stripped with Strip-T-Ease using a
direct spraying system. Allow the product to dwell on the surface for 15
minutes. High pressure-wash the surface to remove the stain.
Related Products
For application use p/n 1059 Delavan pump and lance assembly. Use 15 gallon tank p/n 1067. Another option is p/n 1883, 2 gallon pump up sprayer. Always rinse equipment with clean water at the end of each job. To set up other application systems check the EnviroSpec catalog for a large
assortment of direct sprayers, pumps, chemical line and fittings.
Make it a practice to always read and insist your employees read and understand
the MSDS that accompanies this product.
