● Fits Beckett & Wayne Burners

#1410 115V (2456U)

#1411 115V (2900U)

#1412 13.5V (21699U)

#1413 12V (21539)

#1414 115/240V (21344)

#1415 1/4 240V (2899)

#1390 12 Volt ADC for heaters up to 6 GPM

#1391 12 Volt SDC for heaters over 6 GPM

#1393 115 Volt AFG for heaters up to 6 GPM

#1394 115 Volt SF for heaters over 6 GPM

● If you own a hot water pressure washer - you must own one of these. You’ll be able to tell in 5 seconds what it will take you many hours to figure out without it!

#1947

#1367 FLOW SWITCH, VERTICAL

#1368 FLOW SWITCH, Vertical or Horizontal

#1369 FLOW SWITCH, TMT, 12 GPM

#2272 PHOENIX FLOW, RATED TO 18 GPM

● Fits Beckett & Suntec

#1392 for 220 Volt

#1418 for 120 Volt

#1417 for 12 Volt

● Mounts on discharge side of heating coil

● Temp range from 60 to 230 degrees

#1426

● Remote mount the fuel filter and take the load off the fuel pump. Makes it much easier to replace and service the fuel pump without the filter being attached.

#1115

● Fits Beckett & Wayne Burners

#1379 1.00 GPH

#1380 1.25 GPH

#1381 1.50 GPH

#1382 1.75 GPH

#1383 2.00 GPH

#1384 2.25 GPH

#1385 2.50 GPH

#1386 2.75 GPH

#1387 3.00 GPH

● Shuts down fuel flow if

water reaches 230 degrees

#1107

● 1” Thick x 24” Wide x 5’ Long

Enough for One Coil

#1037

● Mounts on low pressure side of pump.

● Open the trigger gun and indust air into the valve to push water out and keep machine from freezing.

#1074

● Stops burner smoking and keep the coils clean

#6998 Pint

#6999 Quart

LOST A COIL?

We have coils for any machine

at the industry’s best price!

800-346-4876

● 200 PSI - Includes connector

● Super easy installation

● a ‘Must Have’ on every hot water washer

#1128

● For Beckett or Wayne burners

● Rated to 50 AMPS @ 12 Volts

#1388

● Guessing is probably not going to get you to far when it comes to setting the electrodes for a burner. You really need this tool.

#4501

How to set up a...

BURNER DIAGNOSTIC CENTER

and diagnose a problem in 2-seconds

instead of 2-hours or 2-days!

#1399 SunTec Pump, A2VA7116

#1400 SunTec Pump, A1VA7112

#1402 SunTec Pump, A1YA7912

#1397 Beckett Pump, 115 Volt Solenoid included

#1398 Beckett Pump, 12 Volt Solenoid included

#1396 Repair Kit for 12 Volt Solenoid

#1395 Repair Kit for 115 Volt Solenoid

● Mounts on the inlet side of the pump

● As the pump pulls water the burner cons on

#1373 For Gas Engines

#1374 For Electric Motors

● The MTM Series is the best buy & most popular

#1794 M-T-M

#1793 Element

#1419 Racor

#1420 Element

● Takes the shock out of 12Volts

● Extends the life of the transformer

● Handles up to 80 AMPS

#2039

#1370 3,650 PSI, 1/4” MPT

#1371 3,650 PSI, 3/8” MPT

#1372 6,500 PSI, 1/4” MPT

● Allison Series is our most popular

● The closest ‘dead-band’ response of all the thermostats listed here.

● Re-engages the burner with 8 degree temp drop

#C160-44

Shuts burner off

at 160°

#C200-44

Shuts burner off

at 200°